Subaru Forester Body Electrical System 1999 2000 (13) PDF

3. REAR WIPER RELAY
1) Connect battery to terminal No. 1 and ground
terminal No. 2.
2) Check continuity between terminals.
When current
flows
Between terminals
No. 3 and No. 4
Continuity does
not exist.
Between terminals
No. 3 and No. 5
Continuity exists.
When current
does not flow
Between terminals
No. 3 and No. 4
Continuity exists.
Between terminals
No. 3 and No. 5
Continuity does
not exist.
Between terminals
No. 1 and No. 2
Continuity exists.
S6M0075B
7. Rear Window Defogger
A: INSPECTION
1. HEAT WIRES
1) Start the engine so that battery is being
charged.
2) Turn defogger switch to ON.
3) Check each heat wire at its center position for
discontinuity by setting direct current voltmeter.
NOTE:
Normal indication is about 6 volts.
G6M0135
When measuring voltage, wind a piece of tin foil
around the tip of the tester probe and press the foil
against the wire with your finger.
G6M0136
14
6-2 [W6C3] SERVICE PROCEDURE
7. Rear Window Defogger

Subaru Forester Body Electrical System 1999 2000 (13) Summary of Content

3. REAR WIPER RELAY1) Connect battery to terminal No. 1 and groundterminal No. 2.2) Check continuity between terminals.When currentflowsBetween terminalsNo. 3 and No. 4Continuity doesnot exist.Between terminalsNo. 3 and No. 5Continuity exists.When currentdoes not flowBetween terminalsNo. 3 and No. 4Continuity exists.Between terminalsNo. 3 and No. 5Continuity doesnot exist.Between terminalsNo. 1 and No. 2Continuity exists.S6M0075B7. Rear Window DefoggerA: INSPECTION1. HEAT WIRES1) Start the engine so that battery is beingcharged.2) Turn defogger switch to ON.3) Check each heat wire at its center position fordiscontinuity by setting direct current voltmeter.NOTE: Normal indication is about 6 volts.G6M0135 When measuring voltage, wind a piece of tin foilaround the tip of the tester probe and press the foilagainst the wire with your finger.G6M0136146-2 [W6C3] SERVICE PROCEDURE7. Rear Window Defogger