Subaru Forester Brakes 1999 2000 (33) PDF

14. ABS Control Module and Hydraulic Control Unit (ABSCM&H/U)
A: REMOVAL
B4M1220C
(1) Stud bolt
(2) Damper
(3) ABS control module and hydrau-
lic control unit
(4) Front-LH outlet
(5) Secondary inlet
(6) Front-RH outlet
(7) Primary inlet
(8) Rear-LH outlet
(9) Rear-RH outlet
(10) Bracket
Tightening torque: Nm (kg-m, ft-lb)
T1:
18
5 (1.8
0.5, 13.0
3.6)
T2:
29
7 (3.0
0.7, 21.7
5.1)
T3:
32
10 (3.3
1.0, 24
7)
1) Disconnect ground cable from battery.
2) Remove air intake duct from engine compart-
ment to facilitate removal of ABSCM&H/U.
3) Use an air gun to get rid of water around the
ABSCM&H/U.
CAUTION:
The contact will be insufficient if the terminal
gets wet.
4) Pull on the lock of the ABSCM&H/U connector
to remove it.
B4M1224B
(1) Lock
(2) ABSCM&H/U
5) Disconnect connector from ABSCM&H/U.
50
4-4 [W14A0] SERVICE PROCEDURE
14. ABS Control Module and Hydraulic Control Unit (ABSCM&H/U)

Subaru Forester Brakes 1999 2000 (33) Summary of Content

14. ABS Control Module and Hydraulic Control Unit (ABSCMH/U)A: REMOVALB4M1220C(1) Stud bolt(2) Damper(3) ABS control module and hydrau-lic control unit(4) Front-LH outlet(5) Secondary inlet(6) Front-RH outlet(7) Primary inlet(8) Rear-LH outlet(9) Rear-RH outlet(10) BracketTightening torque: Nm (kg-m, ft-lb)T1:185 (1.80.5, 13.03.6)T2:297 (3.00.7, 21.75.1)T3:3210 (3.31.0, 247)1) Disconnect ground cable from battery.2) Remove air intake duct from engine compart-ment to facilitate removal of ABSCMH/U.3) Use an air gun to get rid of water around theABSCMH/U.CAUTION:The contact will be insufficient if the terminalgets wet.4) Pull on the lock of the ABSCMH/U connectorto remove it.B4M1224B(1) Lock(2) ABSCMH/U5) Disconnect connector from ABSCMH/U.504-4 [W14A0] SERVICE PROCEDURE14. ABS Control Module and Hydraulic Control Unit (ABSCMH/U)