Subaru Forester clutch 1999 2000 (7) PDF

1) While pushing clutch release lever to pivot and
twisting it to both sides, fit retainer spring onto the
constricted portion of pivot.
NOTE:
Apply grease (SUNLIGHT 2: P/N 003602010) to
contact point of clutch release lever and operating
cylinder.
Confirm that retainer spring is securely fitted by
observing it through the main case hole.
2) Install clutch release bearing and fasten it with
two clips.
3) Install clutch release lever sealing.
4) Install operating cylinder.
Tightening torque:
T: 37
3 Nm (3.8
0.3 kg-m, 27.5
2.2 ft-lb)
B2M1257L
(A) Clutch release lever
(B) Retainer spring
(C) Clutch release bearing
(D) Clip
(E) Clutch release lever sealing
(F) Operating cylinder
5) After remounting engine and transmission on
body.
<Ref. to 2-11 [W2C0].>
6) Bleed air from oil line with the help of a co-
worker.
<Ref. to 2-10 [W2A0].>
4. Clutch Disc and Cover
A: REMOVAL
1) Install ST on flywheel.
ST 498497100 CRANKSHAFT STOPPER
S2M1847A
(A) Clutch cover
2) Remove clutch cover and clutch disc.
CAUTION:
Take care not to allow oil on the clutch disc
facing.
Do not disassemble either clutch cover or
clutch disc.
3) Remove flywheel.
S2M1848A
(A) Flywheel
8
2-10 [W4A0] SERVICE PROCEDURE
4. Clutch Disc and Cover

Subaru Forester clutch 1999 2000 (7) Summary of Content

1) While pushing clutch release lever to pivot andtwisting it to both sides, fit retainer spring onto theconstricted portion of pivot.NOTE: Apply grease (SUNLIGHT 2: P/N 003602010) tocontact point of clutch release lever and operatingcylinder. Confirm that retainer spring is securely fitted byobserving it through the main case hole.2) Install clutch release bearing and fasten it withtwo clips.3) Install clutch release lever sealing.4) Install operating cylinder.Tightening torque:T: 373 Nm (3.80.3 kg-m, 27.52.2 ft-lb)B2M1257L(A) Clutch release lever(B) Retainer spring(C) Clutch release bearing(D) Clip(E) Clutch release lever sealing(F) Operating cylinder5) After remounting engine and transmission onbody.Ref. to 2-11 [W2C0].6) Bleed air from oil line with the help of a co-worker.Ref. to 2-10 [W2A0].4. Clutch Disc and CoverA: REMOVAL1) Install ST on flywheel.ST 498497100 CRANKSHAFT STOPPERS2M1847A(A) Clutch cover2) Remove clutch cover and clutch disc.CAUTION: Take care not to allow oil on the clutch discfacing. Do not disassemble either clutch cover orclutch disc.3) Remove flywheel.S2M1848A(A) Flywheel82-10 [W4A0] SERVICE PROCEDURE4. Clutch Disc and Cover