Subaru Forester Doors and Windows 1999 2000 (16) PDF

6. Rear Gate Glass
A: REMOVAL
1) Remove rear wiper and rear gate trim.
2) Disconnect connector from rear defogger termi-
nal.
3) Remove glass in the same manner as wind-
shield.
NOTE:
A matching pin is cemented to corners of the glass
on the compartment side. Use a piano wire when
cutting each pin.
G5M0412
B: INSTALLATION
1) Install a new rubber strip (A) by aligning it with
the end of the rear gate glass (B).
S5M0208B
2) Install glass in the same manner as windshield.
S5M0209A
3) About one hour after installation, test for water
leakage. Leave vehicle for 24 hours before using
it.
4) Connect rear defogger connections.
5) Install rear gate trim and rear wiper.
33
[W6B0] 5-2SERVICE PROCEDURE
6. Rear Gate Glass

Subaru Forester Doors and Windows 1999 2000 (16) Summary of Content

6. Rear Gate GlassA: REMOVAL1) Remove rear wiper and rear gate trim.2) Disconnect connector from rear defogger termi-nal.3) Remove glass in the same manner as wind-shield.NOTE:A matching pin is cemented to corners of the glasson the compartment side. Use a piano wire whencutting each pin.G5M0412B: INSTALLATION1) Install a new rubber strip (A) by aligning it withthe end of the rear gate glass (B).S5M0208B2) Install glass in the same manner as windshield.S5M0209A3) About one hour after installation, test for waterleakage. Leave vehicle for 24 hours before usingit.4) Connect rear defogger connections.5) Install rear gate trim and rear wiper.33[W6B0] 5-2SERVICE PROCEDURE6. Rear Gate Glass