Subaru Forester Doors and Windows 1999 2000 (17) PDF

7. Rear Quarter Glass
A: REMOVAL
1) Remove rear quarter molding on corner.
2) Remove glass in the same manner as windshield.
S5M0388A
B: INSTALLATION
1) Finish surface of adhesive layer on body:
Using a putty knife, etc., cut layer of adhesive stick
firmly to body and finish it into a smooth surface of
about 2 mm (0.08 in) in thickness.
CAUTION:
Be careful not to damage body finish.
G5M0497
2) Cleaning of body surface:
(1) Remove chips, dirt and dust from body sur-
face.
(2) Clean body wall surface and upper surface
of adhesive layer with a solvent such as alcohol
or white gasoline.
3) Cleaning glass:
(1) Remove dirt and dust from surface of glass
to be adhered.
(2) Clean surface of glass to be adhered with
alcohol or white gasoline.
4) Application of primer:
(1) Using a sponge, apply primer to surface of
glass to be adhered.
(2) Apply primer to surface of body to be
adhered.
CAUTION:
If primer has dropped on body finish, it is
hard to wipe it off. So protect with masking.
Primer must not project from black frame of
glass.
After applying primer, let it dry naturally for
about 10 minutes.
G5M0495
34
5-2 [W7A0] SERVICE PROCEDURE
7. Rear Quarter Glass

Subaru Forester Doors and Windows 1999 2000 (17) Summary of Content

7. Rear Quarter GlassA: REMOVAL1) Remove rear quarter molding on corner.2) Remove glass in the same manner as windshield.S5M0388AB: INSTALLATION1) Finish surface of adhesive layer on body:Using a putty knife, etc., cut layer of adhesive stickfirmly to body and finish it into a smooth surface ofabout 2 mm (0.08 in) in thickness.CAUTION:Be careful not to damage body finish.G5M04972) Cleaning of body surface:(1) Remove chips, dirt and dust from body sur-face.(2) Clean body wall surface and upper surfaceof adhesive layer with a solvent such as alcoholor white gasoline.3) Cleaning glass:(1) Remove dirt and dust from surface of glassto be adhered.(2) Clean surface of glass to be adhered withalcohol or white gasoline.4) Application of primer:(1) Using a sponge, apply primer to surface ofglass to be adhered.(2) Apply primer to surface of body to beadhered.CAUTION: If primer has dropped on body finish, it ishard to wipe it off. So protect with masking. Primer must not project from black frame ofglass. After applying primer, let it dry naturally forabout 10 minutes.G5M0495345-2 [W7A0] SERVICE PROCEDURE7. Rear Quarter Glass