Subaru Forester Emission Control System and Vacuum Fitting 1999 2000 (4) PDF

4) Take out purge control solenoid valve.
5) Disconnect connector from purge control sole-
noid valve.
6) Disconnect vacuum hoses from purge control
solenoid valve.
S2M0056
7) Install in the reverse order of removal.
Tightening torque:
15.7
1.5 Nm (1.6
0.15 kg-m, 11.6
1.1
ft-lb)
B2M2384
CAUTION:
Carefully connect the evaporation hoses.
B2M1893B
(A) To fuel pipe
(B) To intake manifold
5. Fuel Temperature Sensor
A: REMOVAL
1) Release fuel pressure. <Ref. to 2-8 [W1A0].>
2) Open fuel filler lid, and remove fuel filler cap.
B2M3197
3) Disconnect battery ground cable.
G6M0095
4) Remove the floor box located just behind the
rear seat.
5) Remove service hole cover.
S2M0246
6
2-1 [W5A0] SERVICE PROCEDURE
5. Fuel Temperature Sensor

Subaru Forester Emission Control System and Vacuum Fitting 1999 2000 (4) Summary of Content

4) Take out purge control solenoid valve.5) Disconnect connector from purge control sole-noid valve.6) Disconnect vacuum hoses from purge controlsolenoid valve.S2M00567) Install in the reverse order of removal.Tightening torque:15.71.5 Nm (1.60.15 kg-m, 11.61.1ft-lb)B2M2384CAUTION:Carefully connect the evaporation hoses.B2M1893B(A) To fuel pipe(B) To intake manifold5. Fuel Temperature SensorA: REMOVAL1) Release fuel pressure. Ref. to 2-8 [W1A0].2) Open fuel filler lid, and remove fuel filler cap.B2M31973) Disconnect battery ground cable.G6M00954) Remove the floor box located just behind therear seat.5) Remove service hole cover.S2M024662-1 [W5A0] SERVICE PROCEDURE5. Fuel Temperature Sensor