Subaru Forester Engine 1999 2000 (14) PDF

7. Cylinder Block
A: REMOVAL
1. RELATED PARTS
NOTE:
Before conducting this procedure drain engine oil
completely if applicable.
1) Remove intake manifold. <Ref. to 2-7 [W3A0].>
2) Remove timing belt. <Ref. to 2-3 [W3A0].>
3) Remove A/C compressor bracket. (With A/C
model)
4) Remove generator and A/C compressor with
their brackets.
5) Remove cylinder head bolts in alphabetical
sequence shown in figure.
CAUTION:
Leave bolts (a) and (c) engaged by three or four
threads to prevent cylinder head from falling.
B2M2628A
6) While tapping cylinder head with a plastic
hammer, separate it from cylinder block.
7) Remove bolts (a) and (b) to remove cylinder
head.
B2M2628A
8) Remove cylinder head gasket.
CAUTION:
Do not scratch the mating surface of cylinder
head and cylinder block.
9) Similarly, remove right side cylinder head.
10) Remove clutch housing cover (MT vehicles
only).
11) Remove flywheel (MT vehicles only) or drive
plate (AT vehicles only).
Using ST, lock crankshaft.
ST 498497100 CRANKSHAFT STOPPER
S2M1818A
S2M1870A
12) Remove oil separator cover.
13) Remove water by-pass pipe for heater.
14) Remove water by-pass pipe between oil
cooler and water pump (AT vehicles only).
S2M0305
15) Remove water pump.
39
[W7A1] 2-3SERVICE PROCEDURE
7. Cylinder Block

Subaru Forester Engine 1999 2000 (14) Summary of Content

7. Cylinder BlockA: REMOVAL1. RELATED PARTSNOTE:Before conducting this procedure drain engine oilcompletely if applicable.1) Remove intake manifold. Ref. to 2-7 [W3A0].2) Remove timing belt. Ref. to 2-3 [W3A0].3) Remove A/C compressor bracket. (With A/Cmodel)4) Remove generator and A/C compressor withtheir brackets.5) Remove cylinder head bolts in alphabeticalsequence shown in figure.CAUTION:Leave bolts (a) and (c) engaged by three or fourthreads to prevent cylinder head from falling.B2M2628A6) While tapping cylinder head with a plastichammer, separate it from cylinder block.7) Remove bolts (a) and (b) to remove cylinderhead.B2M2628A8) Remove cylinder head gasket.CAUTION:Do not scratch the mating surface of cylinderhead and cylinder block.9) Similarly, remove right side cylinder head.10) Remove clutch housing cover (MT vehiclesonly).11) Remove flywheel (MT vehicles only) or driveplate (AT vehicles only).Using ST, lock crankshaft.ST 498497100 CRANKSHAFT STOPPERS2M1818AS2M1870A12) Remove oil separator cover.13) Remove water by-pass pipe for heater.14) Remove water by-pass pipe between oilcooler and water pump (AT vehicles only).S2M030515) Remove water pump.39[W7A1] 2-3SERVICE PROCEDURE7. Cylinder Block