Subaru Forester Engine Lubrication System 1999 2000 (4) PDF

E: INSTALLATION
Install in the reverse order of removal.
Observe the following:
1) Apply fluid packing to matching surfaces of oil
pump.
Fluid packing:
THREE BOND 1215 or equivalent
2) Replace O-ring (A) with a new one.
S2M0739B
3) Apply a coat of engine oil to the inside of the oil
seal.
S2M0118B
4) Be careful not to scratch oil seal when installing
oil pump on cylinder block.
5) Position the oil pump, aligning the notched area
with the crankshaft, and push the oil pump straight.
CAUTION:
Make sure the oil seal lip is not folded.
6) Install oil pump.
Tightening torque:
T: 6.4 Nm (0.65 kg-m, 4.7 ft-lb)
S2M0740B
2. Oil Pan and Oil Strainer
A: REMOVAL
1) Set the vehicle on the lift.
2) Disconnect battery ground cable.
G6M0095
3) Remove air intake duct and air cleaner assem-
bly. <Ref. to 2-7 [W1A0].>
H2M2929
4) Disconnect front oxygen (A/F) sensor connec-
tor.
B2M3439
9
[W2A0] 2-4SERVICE PROCEDURE
2. Oil Pan and Oil Strainer

Subaru Forester Engine Lubrication System 1999 2000 (4) Summary of Content

E: INSTALLATIONInstall in the reverse order of removal.Observe the following:1) Apply fluid packing to matching surfaces of oilpump.Fluid packing:THREE BOND 1215 or equivalent2) Replace O-ring (A) with a new one.S2M0739B3) Apply a coat of engine oil to the inside of the oilseal.S2M0118B4) Be careful not to scratch oil seal when installingoil pump on cylinder block.5) Position the oil pump, aligning the notched areawith the crankshaft, and push the oil pump straight.CAUTION:Make sure the oil seal lip is not folded.6) Install oil pump.Tightening torque:T: 6.4 Nm (0.65 kg-m, 4.7 ft-lb)S2M0740B2. Oil Pan and Oil StrainerA: REMOVAL1) Set the vehicle on the lift.2) Disconnect battery ground cable.G6M00953) Remove air intake duct and air cleaner assem-bly. Ref. to 2-7 [W1A0].H2M29294) Disconnect front oxygen (A/F) sensor connec-tor.B2M34399[W2A0] 2-4SERVICE PROCEDURE2. Oil Pan and Oil Strainer